Dell PowerVault ML6000 Manuel d'utilisateur Page 370

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 438
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 369
Chapter 12 Installing, Removing, and Replacing
Adding, Removing, and Replacing the FC I/O Fan Blade
Dell PowerVault ML6000 User’s Guide 370
6 Remove and discard the necessary number of the black rubber
protective covers from the ports on the FC I/O blades.
7 Reconnect the FC cables to the appropriate FC ports on the FC I/O
blade.
8 Save the library configuration (see Saving the Library Configuration
on page 385).
Adding, Removing, and Replacing the FC I/O Fan Blade
Each FC I/O blade is cooled by a fan blade. The fan blade is always
installed in the bay to the right of the FC I/O blade. Each 9U Library
Expansion Module has four bays and can accommodate two FC I/O
blades and two fan blades.
The recommended order of installing the FC I/O blade and fan in the 9U
Library Expansion Module is starting from the bottom two bays and
moving up.
Note: The LEDs for the FC I/O blade are on the bottom of the
blade when the blade is correctly installed in the 9U
Library Expansion Module.
Caution: Fibre optical cables will be damaged if they are bent at
more than a four-inch arc.
Note: After you replace the FC I/O blade, the library ensures
that the FC I/O blade is loaded with the proper firmware.
This firmware is based on the currently installed level of
library firmware. If the autoleveling process fails, the FC
I/O blade becomes inoperable and the library creates a
ticket to report the issue. For information about LED
behaviors on blades during autoleveling operations, see
Blade Status LEDs on page 396.
Vue de la page 369
1 2 ... 365 366 367 368 369 370 371 372 373 374 375 ... 437 438

Commentaires sur ces manuels

Pas de commentaire