Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 290)

100

101

Chapter 12 Installing, Removing, and Replacing

Permanently Removing 9U Library Expansion Modules From an Existing Library

Dell PowerVault ML6000 User’s Guide 290

7 Open the module’s access door and raise the guide pin by pulling it

up and turning it slightly as if it were a screw. Otherwise, the guide

pin may scratch the front doors of the module beneath it.

8 From the front of the library, slide the entire module toward you and

lift it off of the module below it.

9 Repeat these procedures for each module that you intend to remove.

10 Remove and replace the cover plates, if appropriate (see Figure 39).

a If you plan to stack the 5U Library Control Module at the top of

the library, and if a 9U Library Expansion Module will be located

below it, remove the 5U Library Control Module’s bottom cover

plate and the 9U Library Expansion Module‘s top plate.

b If you plan to stack the 5U Library Control Module between 9U

Library Expansion Modules, remove both the top and bottom

plates of the 5U Library Control Module. Also remove the top

plate of the 9U Library Expansion Module located below the 5U

Library Control Module and the bottom plate of the 9U Library

Expansion Module located above the 5U Library Control

Module.

c If you plan to stack the 5U Library Control Module at the bottom

of the library, and if a 9U Library Expansion Module will be

located above it, remove the 5U Library Control Module’s top

plate and the 9U Library Expansion Module’s bottom plate.

Caution: Before removing the 5U Library Control Module’s

bottom cover plate, the robot assembly must be

parked as described in Preparing to Remove or

Replace a Module on page 277.

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 437 438

Commentaires sur ces manuels

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 290

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Dell PowerVault ML6000