Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 158)

Chapter 8 Library Managed Encryption

Configuring the Dell Encryption Key Manager (EKM) on the Library

Dell PowerVault ML6000 User’s Guide 158

• Enter library Diagnostics. From the Web client select Tools >

Diagnostics, and click OK to the message that appears. From the

Diagnostics menu, select EKM > EKM Path Diagnostics.

• Select Setup > Encryption > System Configuration or Setup >

Encryption > Partition Configuration and click the link that says

“Click here to run EKM Path Diagnostics.”

2 Click OK to start the diagnostics.

3 The library performs the diagnostics and displays pass/fail results on

each of the tests in the Progress Window.

4 Do one of the following:

• If Completed appears in the Progress Window, the diagnostics

were performed (this does not mean that the diagnostics passed,

just that the diagnostics were performed). Click Close to close the

Progress Window.

• If Failure appears in the Progress Window, the diagnostics were

not performed. Follow the instructions listed in the Progress

Window to resolve any issues that occurred during the operation.

5 If you are entered the Diagnostics menu, select Exit from the menu

bar and then click OK in the dialog box that appears.

Using Automatic EKM

Path Diagnostics 8

You can enable the library to automatically perform EKM Path

Diagnostics at selected intervals. During each interval, the library tests

every configured key server. The default test interval is four hours. The

library generates a RAS ticket if there are problems.

Note: Performing Diagnostics will log off all other users of

the same or lower privileges and take your partitions

offline. When you exit Diagnostics, the partitions

automatically come back online.

Note: The diagnostics tests may take several minutes to

complete.

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 437 438

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 158