Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 129)

Chapter 5 Configuring Your Library

Configuring System Settings

Dell PowerVault ML6000 User’s Guide 129

Enable SNMP V1/V2 5

Enables Simple Network Management Protocol (SNMP) V1 and V2c

services to run on the library. This option is disabled by default.

Enable IPv6 5

Enables support for IPv6. This option is disabled by default.

The path to open the appropriate screen is as follows:

• From the operator panel, select Setup > System Settings.

Enable SMI-S 5

Enables the SMI-S service to run on the library. This setting is disabled by

default.

The path to open the appropriate screen is as follows:

• From the operator panel, select Setup > System Settings.

Unlabeled Media

Detection 5

At bootup and other times the library performs an inventory of all slots

and media. If a slot contains media with an unreadable barcode label (for

example, the label is missing, torn, or marked up), the scanner cannot

identify it, so the library normally reports the slot as empty.

With the Unlabeled Media Detection feature, you can configure the

library to detect and report which slots contain media with unreadable

barcodes. Since cartridges with unreadable barcodes will not work for

Note: SNMP v3 is always enabled. For more information on

SNMP, see Configuring SNMP Settings on the Library on

page 66.

Note: This setting differs from opening the SNMP port in the

Tools > Security menu (see Configuring Library Security

Settings on page 124). In order to run SNMP, the port must

be open and the SNMP service must be enabled.

Note: This setting differs from opening the SMI-S port in the

Tools > Security menu (see Configuring Library Security

Settings on page 124). In order to run SMI-S, the port must

be open and the SMI-S service must be enabled.

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 437 438

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 129