Dell W-IAP103 Guide de l'utilisateur télécharger pdf (Page 292)

100

101

292 | show ap monitor Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide

show ap monitor

show ap monitor {active-laser-beams|ap-list|ap-wired-mac <mac>|arp-cache| containment-info |

sta-list | state <mac> | stats <mac> | status}

Description

This command shows information for W-IAP Air Monitors.

Syntax

Parameter Description

active-laser-beams

Shows active laser beam generators. The output of this command shows a list of

all APs that are actively performing policy enforcement containment such as rogue

containment. This command can tell us which AP is sending out deauthorization

frames, although it does not specify which AP is being contained.

ap-list

Shows list of APs being monitored.

ap-wired-mac

Shows the MAC address of the wired W-IAP.

arp-cache

Shows ARP Cache of learned IP to MAC binding

containment-info

Shows containment events and counters triggered by the wired containment and

wireless containment features configured in the ids. The output of this command

shows device and target data for wired containment activity, as well as data for the

following counters. Wireless Containment Counters:

l Last Deauth Timer Tick

l Deauth frames to AP

l Deauth frames to Client

l Last Tarpit Timer Tick

l Tarpit Frames: Probe Response

l Tarpit Frames: Association Response

l Tarpit Frames: Authentication

l Tarpit Frames: Data from AP

l Tarpit Frames: Data from Client

l Last Enhanced Adhoc Containment Timer Tick

l Enhanced Adhoc Containment: Frames To Data Sender

l Enhanced Adhoc Containment: Frames To Data Receiver

l Enhanced Adhoc Containment: Response to Request

Enhanced Adhoc Containment: Replay Response Wired Containment Counters:

l Last Wired Containment Timer Tick

l Last Tagged Wired Containment Timer Tick

l Spoof frames sent

l Spoof frames sent on tagged VLAN

enet-wired-mac

Shows Wired MAC Addresses learned.

ids-state <type>

Shows IDS State.

pot-ap-list

Display the Potential AP table. The Potential AP table shows the following data:

l bssid: the AP’s Basic Service Set Identifier.

l channel: The AP’s current radio channel

l phy type: The radio’s PHY type. Possible values are 802.11a, 802.11a-HT-40,

802.11b/g, 802.11b/g-HT-20.

1 2 ... 287 288 289 290 291 292 293 294 295 296 297 ... 575 576

Commentaires sur ces manuels

Pas de commentaire

Dell W-IAP103 Guide de l'utilisateur Page 292

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN Dell W-IAP103