Dell W-IAP103 Guide de l'utilisateur télécharger pdf (Page 472)

100

101

472 | show uplink Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide

show uplink

show uplink {config|stats}

Description

This command displays uplink configuration details and status of for a W-IAP.

Syntax

Parameter Description

show uplink config

Displays the uplink interface configuration details for a W-IAP.

show uplink stats

Displays the aggregate uplink statistics for a W-IAP

Usage Guidelines

Use this command to view the information about uplink status and configuration for a W-IAP.

Example

The following output is displayed for the show uplink config command:

Uplink preemption :enable

Uplink enforce :none

Ethernet uplink eth0 :DHCP

Internet failover :disable

Max allowed test packet loss:10

Secs between test packets :30

VPN failover timeout (secs) :180

The output of this command provides the following information:

Column Description

Uplink preemption

Indicates if the uplink preemption is enabled.

Uplink enforce

Indicates if any uplinks are enforced.

Ethernet uplink eth0

Indicates if Ethernet uplink is configured.

Max allowed test packet loss

Indicates an allowed number of test packets that can be lost verifying

the Internet availability.

Secs between test packets

Indicates the frequency at which the test packets are sent to verify the

Internet availability.

VPN failover timeout (secs)

Indicates the number of seconds to wait, before trying a different uplink

when a VPN tunnel is down.

The following output is displayed for the show uplink status command:

Uplink preemption :enable

Uplink enforce :none

Ethernet uplink eth0 :DHCP

Uplink Table

------------

Type State Priority In Use

---- ----- -------- ------

1 2 ... 467 468 469 470 471 472 473 474 475 476 477 ... 575 576

Commentaires sur ces manuels

Pas de commentaire

Dell W-IAP103 Guide de l'utilisateur Page 472

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN Dell W-IAP103