Dell W-IAP103 Guide de l'utilisateur télécharger pdf (Page 7)

100

101

Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide Instant CLI | 7

Chapter 1

Instant CLI

Instant supports the use of Command Line Interface (CLI) for scripting purposes. You can access the Instant CLI

through a Secure Shell (SSH).

To enable the SSH access to the Instant CLI:

1. From the Instant UI, navigate to System > Show advanced options.

2. Select Enabled from the Terminal access drop-down list.

3. Click OK.

Connecting to a CLI Session

On connecting to a CLI session, the system displays its host name followed by the login prompt. Use the

administrator credentials to start a CLI session. For example:

(Instant AP)

User: admin

Password: *****

If the login is successful, the privileged command mode is enabled and a command prompt is displayed. For

example:

(Instant AP)#

The privileged mode provides access to show, clear, ping, traceroute, and commit commands. The configuration

commands are available in the configuration (config) mode. To move from privileged mode to the configuration mode,

enter the following command at the command prompt:

(Instant AP)# configure terminal

The configure terminal command allows you to enter the basic configuration mode and the command prompt is

displayed as follows:

(Instant AP)(config)#

The Instant CLI allows CLI scripting in several other sub-command modes to allow the users to configure individual

interfaces, SSIDs, access rules, and security settings.

You can use the question mark (?) to view the commands available in a privileged mode, configuration mode, or sub-

mode.

Although automatic completion is supported for some commands such as configure terminal, the complete exit

and end commands must be entered at command prompt for successful execution.

Applying Configuration Changes

Each command processed by the Virtual Controller is applied on all the slave W-IAPs in a cluster. When you make

configuration changes on a master W-IAP in the CLI, all associated W-IAPs in the cluster inherit these changes and

subsequently update their configurations. The changes configured in a CLI session are saved in the CLI context.

The CLI does not support the configuration data exceeding the 4K buffer size in a CLI session: therefore, it is

recommended that you configure fewer changes at a time and apply the changes at regular intervals.

To apply and save the configuration changes at regular intervals, use the following command in the privileged mode:

(Instant AP)# commit apply

1 2 3 4 5 6 7 8 9 10 11 12 ... 575 576

Dell W-IAP103 Guide de l'utilisateur Page 7

Commentaires sur ces manuels

Dell W-IAP103 Guide de l'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN Dell W-IAP103