Dell W-IAP103 Guide de l'utilisateur télécharger pdf (Page 9)

100

101

Using Sequence Sensitive Commands

The Instant CLI does not support positioning or precedence of sequence-sensitive commands. Therefore, it is

recommended that you remove the existing configuration before adding or modifying the configuration details for

sequence-sensitive commands. You can either delete an existing profile or remove a specific configuration by using

the no… commands.

The following table lists the sequence-sensitive commands and the corresponding no command to remove the

configuration.

Sequence-Sensitive Command Corresponding no command

opendns <username <password> no opendns

rule <dest> <mask> <match> <protocol> <start-port>

<end-port> {permit |deny | src-nat | dst-nat {<IP-

address> <port>| <port>}}[<option1…option9>]

no rule <dest> <:mask> <match>

{permit | deny | src-nat | dst-nat}

mgmt-auth-server <auth-profile-name>

no mgmt-auth-server <auth-profile-

name>

set-role <attribute>{{equals| not-equals| starts-

with| ends-with| contains} <operator> <role>| value-

of}

no set-role <attribute>{{equals|

not-equals| starts-with| ends-with|

contains} <operator>| value-of}

no set-role

set-vlan <attribute>{{equals| not-equals| starts-

with| ends-with| contains} <operator> <VLAN-ID>|

value-of}

no set-vlan <attribute>{{equals|

not-equals| starts-with| ends-with|

contains} <operator>| value-of}

no set-vlan

auth-server <name> no auth-server <name>

Table 5:

Sequence-Sensitive Commands

Saving Configuration Changes

The

running-config

holds the current W-IAP configuration, including all pending changes which are yet to be saved.

To view the running-config of a W-IAP, use the following command:

(Instant AP) # show running-config

When you make configuration changes through the CLI, the changes affect the current running configuration only. To

save your configuration changes, use the following command in the privileged Exec mode:

(Instant AP)# write memory

Commands that Reset the W-IAP

If you use the CLI to modify a currently provisioned radio profile, the changes take place immediately. A reboot of the

W-IAP is not required to apply the configuration changes. Certain commands, however, automatically force W-IAP

to reboot. Verify the current network loads and conditions before executing the commands that enforce a reboot of

the W-IAP, as they may cause a momentary disruption in service as the unit resets.

The reload command resets a W-IAP.

Dell Networking W-Series Instant 6.4.0.2-4.1 | CLI Reference Guide Instant CLI | 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 575 576

Dell W-IAP103 Guide de l'utilisateur Page 9

Commentaires sur ces manuels

Dell W-IAP103 Guide de l'utilisateur Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Points d'accès WLAN Dell W-IAP103