Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 286)

Chapter 12 Installing, Removing, and Replacing

Permanently Removing 9U Library Expansion Modules From an Existing Library

Dell PowerVault ML6000 User’s Guide 286

• COD licenses remain the same. After the 9U Library Expansion

Module is removed, there may be more slots licensed than are

available. Only the available slots appear on the License screen.

• All resources in the removed module(s) are removed. A partition

with all resources in the removed module(s) will be present with no

slots or drives. This partition can only be deleted.

Removing the9U Library

Expansion Module 12

To remove the 9U Library Expansion Module:

1 Before removing a module, follow the instructions in Preparing to

Remove or Replace a Module on page 277.

2 For each module that you plan to remove, open the I/E station and

access doors of each module.

Warning: All libraries taller than 14U must be installed in a rack

having a main protective earthing (grounding) terminal,

and power must be supplied via an industrial plug and

socket-outlet and/or an appliance coupler complying with

IEC 60309 (or an equivalent national standard) and having

a protective earth (ground) conductor with a cross

sectional area of at least 1.5 mm

(14 AWG).

To ensure proper airflow and access space, Allow 60 cm

(24 inches) in the front and back of the library.

Warning: Without tape drives, tape cartridges, or power supplies, a

5U Library Control Module weighs approximately 60 lbs

(27.2 kg). A 9U Library Expansion Module, without tape

drives, tape cartridges, or power supplies, exceeds 65 lbs

(29.5 kg).

To avoid serious injury, at least two people are required to

safely lift the modules.

Caution: Before unstacking the modules, the robot assembly must

be parked as described in Preparing to Remove or Replace

a Module on page 277.

1 2 ... 281 282 283 284 285 286 287 288 289 290 291 ... 437 438

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 286