Dell Chassis Management Controller Version 4.50 Guide de l'utilisateur télécharger pdf (Page 137)

Input

• -f <feature> — options are:

– AD — Test AD using simple authentication

– ADKRB — Test AD using Kerberos authentication

– LDAP — Test Generic LDAP

• -u <user>— On the basis of a feature, <user> is user or user@domain.

• -p <password> — Password for the user.

• -d <debug level> — The following bitmask:

– 0x00 — quiet

– 0x01 — verbose

– 0x02 — debug

– 0x04 — info

– 0x08 — warning

– 0x10 — errors

– 0x20 — fatal

– 0x40 — checks

– 0xff — all debug information

– 0xd0 — default debug level for AD and ADKRB.

– 0xf0 and 0xf2 — default debug level for LDAP.

NOTE: -d option is only supported on the firmware interface or firmware interfaces.

Example

• To test AD.

racadm testfeature -f AD -u [email protected] -p dell123

• To test AD.

racadm testfeature -f AD -u [email protected] -p dell123

• To test LDAP.

racadm testfeature -f LDAP -u joe -p dell123 -d 0xf2

testtrap

Description Tests the RAC’s SNMP trap alerting feature by sending a test trap from iDRAC to a specified

destination trap listener on the network.

To run this subcommand, you must have the Test Alerts permission.

NOTE: For iDRAC only, before you run the testtrap subcommand, make sure that the

specified index in the RACADM cfgIpmiPet group is configured properly. The

cfgIpmiPet group is applicable only for iDRAC.

NOTE: For CMC only, before you run the testtrap subcommand, make sure that the specified

index in the RACADM cfgAlerting group is configured properly. The cfgAlerting group is

applicable only for CMC.

Synopsis

racadm testtrap -i <index>

Input -i — Specifies the index of the trap configuration that must be used for the test. Valid values are

from 1 to 4.

137

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 427 428

Pas de commentaire

Dell Chassis Management Controller Version 4.50 Guide de l'utilisateur Page 137