Dell Chassis Management Controller Version 4.50 Guide de l'utilisateur télécharger pdf (Page 138)

100

101

Example

Commands for the cfgIpmiPet group:

• Enable the alert.

racadm config -g cfgIpmiPet -o cfgIpmiPetAlertEnable -i 1

• Set the destination email IP address.

racadm config -g cfgIpmiPet -o cfgIpmiPetAlertDestIpAddr -i 1

192.168.0.110

• View the current test trap settings.

racadm getconfig -g cfgIpmiPet -i <index>

where <index> is a number from 1 to 4

testalert

Description Tests FQDN supported SNMP trap notifications.

To run this subcommand, you must have the Test Alert User Access.

This subcommand is applicable only for iDRAC.

Synopsis

racadm testalert -i <index>

Input -i — Specifies the index of the trap test.

index

must be an integer from 1 to 8 on iDRAC.

Output

Success: Test trap sent successfully

Failure: Unable to send test trap

Example

• Test a trap with index as 1.

racadm testalert -i 1

Test trap sent successfully.

• Test a trap that has not been configured yet.

racadm testalert -i 2

ERROR: Trap at specified index is not currently enabled.

traceroute

Description Traces network path of the routers as the packets traverse from the system to a destination IPv4

address.

To run this subcommand for CMC, you must have the Administrator privilege. For iDRAC, you must

have the Execute Diagnostic Commands permission.

Synopsis

racadm traceroute <IPv4 address>

racadm traceroute 192.168.0.1

Input

racadm traceroute 192.168.0.1

Output

traceroute to 192.168.0.1 (192.168.0.1), 30 hops

max,

40 byte packets

1 192.168.0.1 (192.168.0.1) 0.801 ms 0.246 ms 0.253 ms

138

1 2 ... 133 134 135 136 137 138 139 140 141 142 143 ... 427 428

Commentaires sur ces manuels

Pas de commentaire

Dell Chassis Management Controller Version 4.50 Guide de l'utilisateur Page 138

Commentaires sur ces manuels

Produits connexes et manuels pour Serveurs Dell Chassis Management Controller Version 4.50