Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 261)

Chapter 12 Installing, Removing, and Replacing

Adding 9U Library Expansion Modules to an Existing Library

Dell PowerVault ML6000 User’s Guide 261

Preparing to Install an

Additional 9U Library

Expansion Module 12

Prepare to install an additional 9U Library Expansion Module as follows:

Required tools:

• Phillips #2 screwdriver, for removing and replacing the top cover

plate

• T10 TORX screwdriver, for removing and replacing the bottom cover

plate

You need to unstack the library to install the new 9U Library Expansion

Module at the bottom of the new library configuration.

1 Upgrade the library firmware to a level that can support the number

of modules you are adding. See Updating Library and Tape Drive

Firmware on page 199 for information on upgrading firmware.

2 If you have a partition that spans modules, and you plan to add the

new 9U Library Expansion Module between those modules, you

must delete the partition before adding the new module (see Deleting

Partitions on page 76).

3 Remove all tape cartridges from the library using the import and

export commands of the operator panel or Web client.

4 Power off the library.

5 Disconnect all power cords, network data cables, and module-to-

module cables from all of the modules.

Warning: Without tape drives, tape cartridges, or power supplies, a

5U Library Control Module weighs approximately 60 lbs

(27.2 kg). A 9U Expansion Module, without tape drives,

tape cartridges, or power supplies, exceeds 65 lbs (29.5 kg).

To avoid serious injury, at least two people are required to

safely lift the modules.

Caution: If the library contains a partition that spans modules, and

you plan to install the new 9U Library Expansion Module

between those modules, you must delete the partition

before adding the new module, and re-create the partition

after installing the module.

1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 437 438

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 261