Dell PowerVault ML6000 Manuel d'utilisateur télécharger pdf (Page 312)

Chapter 12 Installing, Removing, and Replacing

Replacing a 9U Library Expansion Module

Dell PowerVault ML6000 User’s Guide 312

6 Loosen the two thumbscrews located at the base of the back of the

module.

7 Open the module’s access door and raise the guide pin by pulling it

up and turning it slightly as if it were a screw. Otherwise, the guide

pin may scratch the front doors of the module beneath it.

8 From the front of the library, slide the entire module toward you and

lift it off of the module below it.

9 Repeat these procedures for each module that you need to remove.

10 Remove and replace the cover plates, if appropriate.

a If you plan to stack the 5U Library Control Module at the top of

the library, and if a 9U Expansion Module will be located below

it, remove the 5U Library Control Module’s bottom cover plate

and the 9U Expansion Module top plate.

b If you plan to stack the 5U Library Control Module between 9U

Expansion Modules, remove both the top and bottom plates of

the 5U Library Control Module. Also remove the top plate of the

9U Expansion Module located below the 5U Library Control

Module and the bottom plate of the 9U Expansion Module

located above the 5U Library Control Module.

c If you plan to stack the 5U Library Control Module at the bottom

of the library, and if a 9U Expansion Module will be located

above it, remove the 5U Library Control Module’s top plate and

the 9U Expansion Module’s bottom plate.

Replacing the 9U

Expansion Module 12

1 Remove all tape drives from the 9U Library Expansion Module that

you are adding. See Adding, Removing, and Replacing Tape Drives

on page 354 for instructions on removing tape drives.

2 Remove the power supplies from the 9U Library Expansion Module

that you are adding. See Adding, Removing, and Replacing Power

Supplies on page 330 for instructions on removing power supplies.

Caution: Before removing the 5U Library Control Module’s

bottom cover plate, the robot assembly must be

parked as described in Preparing to Remove or

Replace a Module on page 277.

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 437 438

Pas de commentaire

Dell PowerVault ML6000 Manuel d'utilisateur Page 312